Battery Nail Penetration Tester

Descrizione

The test shall be carried out at an ambient temperature of 20°C±5°C. Place the battery with a thermocouple (the contact of the thermocouple is fixed on the large surface of the battery) in a fume cupboard, and pierce the center of the largest surface of the battery with a non-corrosive rust-free steel needle of 2-8mm in diameter at the speed of 10mm/s-40mm/s and keep it in place for 5 seconds.

Standard

GB/T 18332.2-2001

MT/T 1051-2007

Specifiche

1. ф2mm-ф8mm high-temperature resistant steel needles.

2. Distance between the tip of the needle and the lower part: 250mm from the plane where the battery is placed. 3.

3. Clamping distance: 150mm

4. 10-40mm/s speed, from the direction perpendicular to the battery pole plate through (steel needle stays in the battery)

5. penetration force: about 2000KG

6. force display: pressure sensing LED display

7. Stroke: about 200mm

8. driving mode: hydraulic drive (or motor drive)

9. made into a box-type equipment device explosion-proof, fire prevention, corrosion resistance, easy to clean.

10. explosion-proof box size (W × H × D): about 450 × 750 × 550mm

11. explosion-proof box material: galvanized sheet baking paint treatment

12. machine size: about 1640 × 570 × 730mm

13. control box size: about 300 × 260 × 170mm

14. weight: about 75KG

15. power requirements: 1 ф220V, 50HZ